Installation of the feed cutting guillotine. As some operators will not be installed correctly to carry out the feed cutting machine, some problems will occur during the operation: the feed cutting machine should be placed or fixed on a firm horizontal base and be stable when running, without large vibrations. The supporting power (diesel, electric or petrol) should be determined before installation and the supporting power should be correctly selected according to the requirements of the product instruction manual. Check whether the diameter of the pulley of the power machine is consistent with the speed of the guillotine. If a small diesel engine is chosen as power, it should be set on a concrete floor and be able to adjust its position backwards and forwards to tension the conveyor belt. If a diesel engine is chosen as the power source, the conveyor belt guard of the tractor and the two castors at the exit end of the feed cutter should be written so that the central drawbar of the tractor is connected to the pin in the centre of the guillotine frame, the suspension on both sides hooks onto the two caster axles and the "V" shaped conveyor belt is adjusted to the right tension with the central drawbar hinge after the pin has been fitted. If an electric motor is used as the power source, the motor shaft should be parallel to the guillotine shaft and the two pulleys should be aligned with their central shafts. The direction of the main shaft of the guillotine should be aligned with the direction of the arrow on the machine housing. In addition, a control door for the motor power supply should be installed near the processing site so that the power can be turned on or off at any time. The guillotine should be mounted smoothly, should be fitted with a protective cover and the grass outlet should be aligned with the natural wind direction. If the machine cannot be moved easily, the grass outlet can be moved by