Whole Cassava, Sweet Potato and Beet Roots: A Square-Hopper Chopper for Tuber Feed — Weiwei Machinery
Roots are cheap feed and difficult feed at the same time. Cassava, sweet potato, beet, carrot and potato all carry good energy, and in a bad season they are the cheapest calories a cattle or goat farm can buy. But tipped into a trough whole, they are also the first thing the animals sort through. Cattle nudge a whole root around the pen, eat the easy end, and leave the rest in the dung. A lump that size is also a choking risk, and it passes through the gut too slowly to do much good.
Chopping them is not as simple as buying a bigger chaff cutter. A forage chopper is designed around long, flexible material that the feed rollers can grip and draw into the blade. A round, wet tuber does neither: it rolls in the chute, arches over the opening and refuses to feed, and when it finally does go in it arrives as a bruised lump rather than a cut piece. This is why so many farms end up with a hammer mill and a wet paste that sours in the trough within a day.
The 9ZP-0.4V is the same frame as our standard small chaff cutter with two changes. The tuber feed is a square vertical hopper and a square-section cutting opening, so a round root cannot roll away from the blade and cannot bridge over the throat. Behind it sits a separate tuber cutting section that slices rather than shreds, and a gear lever sets the length at about 1.7 cm or 3 cm. The long-forage chute stays where it was, so the same machine still handles green and dry maize stalk, rice straw and sweet potato vine.
The numbers are modest on purpose. A 2.2–3 kW motor at 2,800 r/min drives the main shaft at 950 r/min, giving 400–1,200 kg/h — enough for a few hundred head of goats or a small cattle yard, on a machine that weighs 58 kg and measures 1,055 × 920 × 875 mm. It runs on an electric motor, a diesel engine or a gasoline engine, which matters on farms where the three-phase supply is unreliable, and the four wheels mean one person can push it to whichever pen needs feed. Blades are 65Mn steel, heat treated, and the serrated forage blades can be turned to use the second edge.
Use 3 cm pieces for cattle and 1.7 cm for sheep and goats, and mix the cubes through straw or silage rather than feeding them alone, so the ration cannot be sorted. Run the roots through first and the straw afterwards; the dry material clears the chamber and saves a wash-down. Zhengzhou Weiwei Machinery has built feed machinery in Xingyang, Henan since 1980, with ISO 9001 and EU CE certification. Send us your animal count, your root crop and your power supply at WhatsApp +8613526462915 or admin@weiweimachinery.com, or enquire from www.weiweimachinery.com.

