What Stops a 15 kW Chaff Cutter: Feeding, Cut Length and Where the Chopped Grass Lands — Weiwei Machinery
Silage season is short. A machine rated at ten tonnes an hour should empty a 300-tonne pit in a month of afternoons, but buyers regularly report half that. The engine is not the problem. The problem is that the machine has to be stopped to change the cut length, the discharge chute points at the ground so somebody has to shovel, and the feeding table is too short to work with a loader bucket.
The 9ZP-10 is built around a 15 kW motor running at 1,440 rpm, driving a blade disc at 500 rpm with three or four moving blades. Rated capacity is 3 to 10 tonnes per hour depending on material and cut length, and the machine weighs 800 kg in the standard build, 880 kg in the heavy frame version. That is a stationary machine: it wants a poured slab, a three-phase supply and a roof.
The detail that saves the most time is the double gearbox. One gearbox sets the cut length, the second sets the feed rate, which means the operator changes length with a lever instead of pulling the cover and swapping gears. The second gearbox also earns its place when the machine plugs: instead of unbolting the feed table, the operator reverses the rollers and the block comes back out.
Discharge was redesigned for the same reason. The outlet is raised and lengthened and rotates through 360 degrees, so it can be aimed straight into a trailer or a blower pipe rather than onto the floor. On a machine moving ten tonnes an hour, that is the difference between one man driving and two men shovelling.
The cutting head combines blades and hammers on one rotor. The blades cut the stalk to length and the hammers break the joints that a blade alone leaves intact, which matters for corn stalks that cattle otherwise sort out of the trough. All 9ZP series machines are statically balanced at the factory, and the frame, bracket and motor mount are a combined steel structure to hold noise down.
The honest limit: if the herd only needs three tonnes a day, this machine is the wrong purchase. A 4 kW 9ZP-3 at 1 to 3 t/h costs less, draws single-phase-friendly power and does the same job at a third of the throughput. The series runs 1-3 t/h at 4 kW, 1.5-4.5 t/h at 5.5 kW, 2.5-6.5 t/h at 7.5 kW and 3-10 t/h at 15 kW, all with the same geometry, so the choice is settled by daily tonnage, not by price.
Zhengzhou Weiwei Machinery has built feed and forestry machinery in Xingyang, Henan since 1980, holds EU CE and ISO 9001 certification, and ships to more than 40 countries. For the 9ZP-10 specification sheet, freight dimensions or a quotation with the right voltage for your area, message WhatsApp +8613526462915, write to admin@weiweimachinery.com, or check the chaff cutter section at www.weiweimachinery.com.

