Email:admin@weiweimachinery.com Tel:+8619838691608 WhatsApp:+8619838691608 Address:Gaocunsi, Gaocun Township, Xingyang, Henan, China (Mainland)
Product knowledge
Your current location: Home > News > Product knowledge >
How to Operate a Rice Thresher: Preparation, Startup, Threshing Settings and Shutdown
Update:2025-04-01 17:42:34    Views:
A rice thresher goes through four stages in a working day: preparation, startup, threshing and shutdown. Each stage has its own checks, and skipping one is how most avoidable breakdowns begin. The steps below follow the order an operator should work in.
 
Before the machine is switched on, check that every part is in good condition, with nothing loose and nothing damaged. Then clean the machine and clear out the debris left from the last run. Straw and grain dust left in the chamber work their way into bearings and belts, so a short clean at the start saves a long repair later.
 
For a motor-driven unit, connect the power and turn the switch to ON. Let the machine run at low speed for 1 to 2 minutes before any crop goes in. That warm-up lets the operator listen for a strange noise while the machine is still empty, and it brings the moving parts up to working condition before load is applied. Speed is raised only after the warm-up is done.
 
Feeding needs to be even. Crop should go into the feed inlet at a steady rate, because a sudden heavy charge is what blocks the inlet and stalls the rotor. The threshing clearance and the rotation speed are set to suit the rice being harvested, since a wet crop and a dry crop do not thresh the same way. While the machine runs, watch how it sounds and how the straw comes out, and if anything changes, stop it at once and check before going on.
 
At the end of the run, stop feeding first and let the machine finish what is already inside. Then let it idle for 1 to 2 minutes so the residue is thrown clear of the chamber. Finally, on a motor-driven unit, turn the switch to OFF and only then leave the machine.
 
These four stages are short, and following them is what keeps a thresher working season after season. Zhengzhou Weiwei Machinery has built farm machinery since 1980 and holds ISO9001, CE, SGS and TUV certification. Threshers, shellers, chaff cutters, grinders and pellet machines from Weiwei are exported to the Americas, Africa, Southeast Asia and South Asia, with after-sales service and spare parts support.

Relevant Article Recommended

24 hour hotline

+8619838691608

Contact
Tel:0086 371 63283021
WeChat:13939084108      /  19838691608
WhatsApp:+86 198 3869 1608
Email:admin@weiweimachinery.com
Address:Gaocunsi, Gaocun Township, Xingyang, Henan, China (Mainland)
WeChat: 19838691608 Email:admin@weiweimachinery.com Address:Gaocunsi, Gaocun Township, Xingyang, Henan, China (Mainland)

Hotline:

+8619838691608

Wechat Qrcode

WhatsApp