The 9ZF-400 range makes that trap visible. All four models run the same 2.2–3 kW motor, the same 360 mm rotor and the same 3,100 rpm spindle. Only the geometry changes:
- 9ZF-400-20C — 16 hammers, 200–400 kg/h, 55 kg
- 9ZF-400-24B — 24 hammers, 400–600 kg/h, 70 kg
- 9ZF-400-24C — 24 hammers, 400–600 kg/h, 70 kg
- 9ZF-400-30 — 24 or 32 hammers, 600–800 kg/h, 80 kg
What the extra hammers actually do. Tip speed is set by rotor diameter and rpm, and both are fixed here. Adding hammers does not make the tips travel faster; it makes them strike more often per revolution. More strikes per second means each piece of straw is hit sooner after it enters, spends less time rattling around the chamber, and reaches screen size in fewer passes. The result is a higher mass flow through the same screen — up to four times the smallest model — from an identical motor.
Power draw rises with it. The 400-30 with 32 hammers pulls close to the top of the 2.2–3 kW band under load, and it needs a supply that can hold that. A farm running a long extension cable on a single-phase line should be looking at the 20C, not at the biggest number in the table.
Two outlets, two products. Cut forage leaves from the top outlet as chopped straw. Material that passes the 3.0 mm screen leaves from below as meal. The same machine therefore feeds cattle from one spout and poultry, or a small pellet operation, from the other. Running both at once is normal: the upper outlet for the animals that need length, the lower one bagged for sale.
Wear parts are designed for reversal rather than replacement. The 65# manganese blades are double-sided serrated — when one edge dulls, the blade is turned over, but it must go back in the same position, because the rotor is statically balanced. The same rule applies to the hammers. Turning them in place keeps the balance; swapping them from slot to slot does not. UC bearings self-align and tolerate the vibration that comes with an unbalanced rotor, which is why a neglected set of hammers usually shows up first as bearing noise.
Weiwei Machinery has been building farm and forestry machinery since 1980, with CE and ISO9001 certification. If you are unsure whether your material needs 16 hammers or 32, tell us the crop, the moisture and the tonnage per day on WhatsApp +8613526462915 or at admin@weiweimachinery.com, and we will point at one model instead of the whole range.









